antec sonata questions

[rookie1010]

Hello
i am about to move my components from my old case to an antec sonata and have two questions regarding the antec sonata.

the first one is can you guys tell me what are the connectors coming out of the ANtec Sonata PSU. i have managed to identify the goold old Molex, mobo supply and the 4 pin power supply for the mobo. the others i dont understand.

the second one is on the instruction booklet on page 2
the 6th item of ste set up states
"To remove the front bezel door, open the door no more than 90 degree, and gently press the small platic tab at the upper hinge....."

does this mean i can remove the entire front end of the antec sonata and get to the washable air filter. or perhaps it is just the door that hides the 5.25 inch drives and the power switch ....

 

[Ike0069]

1. SATA power connectors.
2. Only the upper door is removable. The filter removes by sliding it out from the bottom.

 

[mshan]

I think one of the power supply leads is a Pentium III connector of some sort. I just tuck it away in an unused drive bay.

 

[rookie1010]

thanks for the replies.

oh, so that is what the tabs are at the bottom.

are the SATA drive power cables the thin ones with a single(?) line of connectors. also i can see a last connector which is 6 x2 pin connector(female), the top pins(slots) being smaller than the ones below? is this the one that you tucked away ?

is there any things (cable wise) i need to be careful about when i plug in my mobo into my new case