You can install the Tuniq Tower 120 in the Antec 900 for an AMD K8 setup.
At first it looked like I had to cut the Fan tab off the door but after looking at the large heatsink base I was able to twist the tower slightly counterclock wise and made the room needed to leave the door uncut and still have the processor covered by the base.
Just do not twist it any more then is absolutly needed because I can just see the socket lever on the lower right so everything is still covered. the little tab in the center that the H-plate slides on keeps the base centered.
Enjoy!
Hope this was helpful so someone. I searched and searched and was about to cut the tab off.
At first it looked like I had to cut the Fan tab off the door but after looking at the large heatsink base I was able to twist the tower slightly counterclock wise and made the room needed to leave the door uncut and still have the processor covered by the base.
Just do not twist it any more then is absolutly needed because I can just see the socket lever on the lower right so everything is still covered. the little tab in the center that the H-plate slides on keeps the base centered.
Enjoy!
Hope this was helpful so someone. I searched and searched and was about to cut the tab off.
Facebook
Twitter