answered

[Fullmetal Chocobo]

"Please note: Molding cannot be installed in square corners without cutting it. The corners of the window must be rounded no steeper than 2.75 inches to maintain a flat profile."

What do they mean by that 2.75". Do they mean it needs atleast 2.75" to clear a 90 angle? I'm not sure. Anyone else have any ideas by what they mean?

Tas.

 

[JEDIYoda]

sheese...kids!
Buy them books send them to school....lol

 

[GalvanizedYankee]

Tas, they are reffering to the radius at the corner. A radius any tighter and the molding will/can buckel presenting
an unattractive result. On your templet just set the radius up at 2.75" on the corners. Any tighter you would have to go
with a square window and cut the molding at a 45 degree angel and match up the sharp corners.

EDIT: After a close look at the pics of that molding going to squared corners would make
installing the window difficult.



jj

 

[Fullmetal Chocobo]

Thanks GY. I just couldn't figure out what measurement they were talking about. Now I guess I don't have to figure out the radius to use--I was just arbitrarily using 2". Thanks!
Tas.