I found a magical secret for my computer. When I change my Cpu voltage to 1.75, I was really able to open it up. The highest fsb i could reach was 187. Whether my voltage was stock at 1.65, I would max at 187 prime stable. I couldn't get 188 until I changed the vcore to 1.75. (Took me few days to get to 1.75) Funny how 1.675, 1.70, 1.725 did relatively nothing. I figured I just had one of those 8rda+ v1.1 boards that needed a vmod. Well I adjusted my voltage to 1.75 I was really able to give myself some headroom. I was able to reach 206 X 11 prime stable, (+19 mhz). Prime doesn't seem to like 207. My temps at the moment are 42 idle and 50 load with MBM using a vantec aeroflow. Do I dare up my voltage and what pt. do I stop. From what I been reading as long as my temps are below 60. I should be fine, right? As it is I am a little uncomfortable with 1.75. This it the hightest I have ever run a T-bred.
Right know I am at
206 X 11 (2600XP TBred), 1.75 Vcore @ 43/50C
Timings 2338, vdimm 2.77
A side note. My MB did not like it when I messed around with the timings. With a lower multi. the board wouldn't boot with relaxed timings. I tried to change the latency, but I had to clear the cmos in order to boot up. (everytime)
Right know I am at
206 X 11 (2600XP TBred), 1.75 Vcore @ 43/50C
Timings 2338, vdimm 2.77
A side note. My MB did not like it when I messed around with the timings. With a lower multi. the board wouldn't boot with relaxed timings. I tried to change the latency, but I had to clear the cmos in order to boot up. (everytime)
Facebook
Twitter