AMD 64 3000+ @ 2.5 unstable

[L o g a r i t h 0]

HTT - 285 x 9
Core Speed - 2565mhz
Voltage - 1.5V

Cas# Latency- 3
RAS# to CAS# Delay- 4
RAS# Precharge- 4
Cycle Time (Tras)-8
Bank Cycle Time (Trc)- 11
DRAM Idle Timer- 16

DDR:FSB = 7/10.

 

[Mogadon]

Up the voltage. Anything upto 1.55V is considered totally safe, i'd happily goto 1.6/1.65V personally although other will tell you different, I wouldn't go above 1.65V and make sure you keep an eye on the temperatures.

You haven't gone wrong at all, you just need the extra voltage, 2565MHz at 1.475 isn't bad at all.

 

[L o g a r i t h 0]

I hestitate adding too much voltage but ill try at 1.5v. So far temps maxed 48C during prime95.

 

[L o g a r i t h 0]

Ok about 7 minutes into priming it froze..

 

[Mogadon]

Man, the chip aint gonna die at 1.55V, if i was my chip i'd take it to 1.65V as long as the temps were good. From what i've seen across the net people's chips only started dying quickly over 1.65V, as long as you aren't thinking about keeping this processor running overclocked for more than 4 years there's really no reason not to go to 1.55V.