Advice required.

Fattysharp

Member
Nov 23, 2005
95
0
0
I recently setup a new machine C2D 6400 , and I just replaced the stock hsc a Scythe Mine B rev2 cooler due to it running hot in the summer heat. I was able to bring down idle temps 6-8C now running at 40-42C idle, and load reaches 53-55C instead of mid to high 60s on the stock cooler. I right now have the scythe vertical fan pointing at my rear exhaust fan. I believe these Temps are fairly standard/safe c2d from everything i have been able to research.

It appears that the real culprit is the BFG 8800gtx couple with the summer heat. It idles at 60-62C, never seen load go beyond 69C and raises my ambient to low-mid 50C. Everything I have research tells me that is a average to low temp for the gpu on stock cooling. My concern here is how the stock heatsink blows hot air back into my case instead of out of it.

The system is stable at stock speeds, i have not had any need to overclock since everything runs smoothly. I wanted to confirm with the cooling guru's though that my temps are safe. My system is in my sig and i will sum up my temps below. I can lower all temps by aprox 3-5 degrees by turning my exhaust fans from med to high, but i am unsure if the extra noise is worth it if everything is safe already.

cpu cores 40-42 idle, 53-55 load.
gpu core 60-62 idle, 69 load.
Ambient Temp 50 idle, 55+ load (this is primarily what I worry about)
Room temp is 25-28 since summer arrived.

Thanks,

Sharp

**Edit: Opps, posted in the wrong forums, I see no option to delete or move it to cooling.
 

nullpointerus

Golden Member
Apr 17, 2003
1,326
0
0
Your temperatures seem fine to me.

Do you have a fan near your HDD's to cool them down?

Considering your CPU and GPU temperatures are safe, the HDD's are the only real problem with high ambient case temperatures. I've lost several to overheating. Basically, as long as they have any kind of airflow (i.e. front 80mm fan) they should be just fine.

EDIT: How is your cable management? Use wire ties to bind wires out of the normal airflow path. You will want air flowing freely from intake to exhaust fans and all of the "hot spots" i.e. CPU, GPU, RAM, HDD, PSU. This might also reduce noise if you turn the fans on high.
 

Fattysharp

Member
Nov 23, 2005
95
0
0
Yes, HD is in the middle bay area, and i am using an 120mm fan at the front of the case that brings air through the front vents, blowing across the hd. The added bonus to the placement is that the it also pushes the fresh air above and below the graphics card. Felt that was needed since the 8800gtx nearly reaches the drive bays, cutting off air flow to the lower area of the mobo.

Thanks for the reply.