Advice on Water Cooling Setup

[ZombieJesus]

Hello any suggestions to improve performace or save cash will help me greatly.

I am only water cooling my cpu which will be overclocked in a big way.


Danger Den TDX with brass top 1/2 inch fittings

Tygon 3603 1/2 ID 3/4 OD

Heatercore from 1977 Bonneville no A/C + shroud (from dangerden Store) 1/2 Fittings

Danger Den CSP-Mag 12 volt Pump

T-line with Poly T and brass fitting with cap or something

MCT-5 fluid



BTW What is the best place to have the T-line.

 

[1sikbITCH]

Can't speak on the pump. I am using an AquaExtreme 50z. I have a 77 bonneville heatercore as well, along with a DangerDen Maze4 cpu block, but I'm cooling a TEC with it. I also am running 2 Delta's at 152 cfm's each strapped to the heatercore
Best advice I can give you is to get 7/16 ID tubing to stretch over your 1/2 fittings. That will help insure no leaks.

Here is a little known secret: http://www.mcmaster.com/

Type in "masterkleer". Instead of a dollar or more a foot for Tygon you're spending 35 cents, and this is also great tubing. I bought about 50 feet of it so I'm good for a few projects