I have Kingston HyperX RAM. It's a 2x512MB kit number KHX3200AK2/1G.
The timings are 2-3-2-6-1.
My machine specs are: Silverstone LC20, Abit NV8, Athlon 3700+ Clawhammer, Zalman 7000 Alcu-LED, 1GB Kingston HyperX, Asus Geforce 6600, Fortron Blue Storm II 500w, Samsung Spinpoint SP2514N, LG H22N, Nexus NXP-301 fan controller.
I wanted to know if the following RAM settings are correct:
>DRAM Configuration
DRAM Timing Selectable Manual
-DRAM Clock DDR400
-CAS Latency Time 2.0
-ROW Cycle Time 11 Clocks
-Row Refresh Cycle Time 13 Clocks
-Min. RAS# Active Time 6 Clocks
-RAS# to CAS# Delay 3 Clocks
-RAS# Precharge Time 2 Clocks
-RAS# to RAS# Delay 2 Clocks
-Write Recovery Time 3 Clocks
-Write to Read Delay 2 Clocks
-Read to Write Delay 3 Clocks
-DRAM Command Rate 1T
-Bank Interleaving Enabled
-Burst Length 8 beats
MTRR mapping mode Continuous
32 bit DRAM Memory Hole Auto
The timings are 2-3-2-6-1.
My machine specs are: Silverstone LC20, Abit NV8, Athlon 3700+ Clawhammer, Zalman 7000 Alcu-LED, 1GB Kingston HyperX, Asus Geforce 6600, Fortron Blue Storm II 500w, Samsung Spinpoint SP2514N, LG H22N, Nexus NXP-301 fan controller.
I wanted to know if the following RAM settings are correct:
>DRAM Configuration
DRAM Timing Selectable Manual
-DRAM Clock DDR400
-CAS Latency Time 2.0
-ROW Cycle Time 11 Clocks
-Row Refresh Cycle Time 13 Clocks
-Min. RAS# Active Time 6 Clocks
-RAS# to CAS# Delay 3 Clocks
-RAS# Precharge Time 2 Clocks
-RAS# to RAS# Delay 2 Clocks
-Write Recovery Time 3 Clocks
-Write to Read Delay 2 Clocks
-Read to Write Delay 3 Clocks
-DRAM Command Rate 1T
-Bank Interleaving Enabled
-Burst Length 8 beats
MTRR mapping mode Continuous
32 bit DRAM Memory Hole Auto
Facebook
Twitter