• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

ABIT KT7-RAID/ATA-100

H

hausdave

Senior member
Is there any way to use the HPT 370 controller on this board to just provide ATA100 suppurt a la its cousin the KA7-100? Is it a requirement to create an array?
 
Yes, you can use it as a ata100 drive and dont have to create a raid. I believe you have to install the drivers so its active and enabled in your bios. I believe where you set up your boot sequence in your bios, where it is normally floppy,ide-0,cd-rom, you change the ide-0 to ATA/100. This may not be necessary to change, but I did on my kt7a-raid board after I installed my o.s.
 
SeaHarp,

Silly question (I hope)...

I just switched my drives from the ATA-66 controller on my KT7-RAID to the
HPT370. Now in Windows neither drive shows the checkbox for DMA. Is this
normal? I do have the drivers for the HTP370 already loaded.

 
You must log in or register to reply here.
Back
Top