Alright guys, new to building computers and definately new to Overclocking. I just got this system up about two days ago. I'm trying to do a modest OC with this board until I get some better memory in a week or so. I'm following the guide found in these forums http://forums.anandtech.com/messageview...atid=28&threadid=1497607&enterthread=y
Two questions.
When it says "set mem to SPD and 100", I don't know what SPD is, and by 100 I would think he means Memclock, and 200 is the lowest I can set it, which I think equates to 100, right?
Second question, where can I get to the Dividers on this board? What is it and where is it in the Bios? Does it say divider(s) or something else?
Any help on this guys is greatly appreciated, and plse excuse my inexperience, I'm trying to learn and I think I'm getting better at it.
Two questions.
When it says "set mem to SPD and 100", I don't know what SPD is, and by 100 I would think he means Memclock, and 200 is the lowest I can set it, which I think equates to 100, right?
Second question, where can I get to the Dividers on this board? What is it and where is it in the Bios? Does it say divider(s) or something else?
Any help on this guys is greatly appreciated, and plse excuse my inexperience, I'm trying to learn and I think I'm getting better at it.
