Hey everyone,
I have the above board and have just purchased two Maxtor ATA100 20G drives. I have followed the install procedure (jumpers etc) and it detects my two HD's on Boot, but I have no knowledge as to how to get into FastTrack and set up my array. You see, I didn't get the [Ctrl F] for SetUp screen, it just detected the drives and continued to Boot. So anyway, the upshot is I have two drives listed [D0] and [D2] DMA 5 (whatever that means) on the Promise screen during detect phase, but upon Fdisk and Format, it only recognizes 20g not 40g. How the **** do I get in there, or what do I do from here? I have searched the forums but come up with nothing so far.
So any help would be a god-send.
Thanks in advance.
Cheers
Jas
helixx_@hotmail.com
I have the above board and have just purchased two Maxtor ATA100 20G drives. I have followed the install procedure (jumpers etc) and it detects my two HD's on Boot, but I have no knowledge as to how to get into FastTrack and set up my array. You see, I didn't get the [Ctrl F] for SetUp screen, it just detected the drives and continued to Boot. So anyway, the upshot is I have two drives listed [D0] and [D2] DMA 5 (whatever that means) on the Promise screen during detect phase, but upon Fdisk and Format, it only recognizes 20g not 40g. How the **** do I get in there, or what do I do from here? I have searched the forums but come up with nothing so far.
So any help would be a god-send.
Thanks in advance.
Cheers
Jas
helixx_@hotmail.com
Facebook
Twitter