- Aug 10, 2005
- 17,768
- 485
- 126
http://www.youtube.com/watch?v=3IelU7FpGUA&
Of course the best test (like this) would be in a pool of salt water.
What I would like have seen them do is use a real amplifier (5+ kW continuous power at speaker impedance). The thermal limits of the voice coil would be greatly augmented with water submersion. Also the damping should reduce overexcursion that such power would cause (basically exceeding XMECH for a few mS does permanent damage). Shallow submersion keeping water around the voice coil where waves could be more readily observed as well as infrasonic wave propagation, etc. Fresh water would be ideal since even a four ohms this is a high voltage test. If the woofer survives all that then a very high power test (30kW) of short duration (<10mS) impulses would be neat too. In air this can do some very strange things (dangerous!) to drivers.
Of course the best test (like this) would be in a pool of salt water.
What I would like have seen them do is use a real amplifier (5+ kW continuous power at speaker impedance). The thermal limits of the voice coil would be greatly augmented with water submersion. Also the damping should reduce overexcursion that such power would cause (basically exceeding XMECH for a few mS does permanent damage). Shallow submersion keeping water around the voice coil where waves could be more readily observed as well as infrasonic wave propagation, etc. Fresh water would be ideal since even a four ohms this is a high voltage test. If the woofer survives all that then a very high power test (30kW) of short duration (<10mS) impulses would be neat too. In air this can do some very strange things (dangerous!) to drivers.
