I have an Intel CA810 motherboard that I have been working on. I have replaced pretty much everything but the board. My questions are 1. The owners manual says ppga processors. I am using a FCPGA 600e. I remember putting a FCPGA in an 810 board before and it not working so I think that might be the problem. The "supported processor" list shows the 600e as a compatible processor.
2. the board might be bad. The board is brand new and never has been tested so it could just be a bad board. The only processors I have at my house ar 2 1gig (which I know won't work because of the 133mhz bus) A P4 1.5 and A tualitin 1.2. I know both of those will not work.
I have pulled out everything that is not necessary tried different sticks of memory and even a different power supply. It powers up and all the fans turn on but it never beeps or sends a signal to the monitor. Any ideas of what else to try?
Thanks
2. the board might be bad. The board is brand new and never has been tested so it could just be a bad board. The only processors I have at my house ar 2 1gig (which I know won't work because of the 133mhz bus) A P4 1.5 and A tualitin 1.2. I know both of those will not work.
I have pulled out everything that is not necessary tried different sticks of memory and even a different power supply. It powers up and all the fans turn on but it never beeps or sends a signal to the monitor. Any ideas of what else to try?
Thanks
