I'm setting up a refurb 8RDA+, and it's got a strange problem. It'll boot, but I get a "7F" error on the diagnostic LED. The board will run for 2-3 minutes, then it shuts down. The CMOS must be cleared before it'll start again.
Anybody have a clue what this error is?
Most of the parts were running on my 8K5A2 board, which I took apart to replace with the 8RDA+. The only new part is a Fortron 350 PS, which worked fine when I tested it the other day. (Amazingly quiet with the 120MM fan!)
Anybody have a clue what this error is?
Most of the parts were running on my 8K5A2 board, which I took apart to replace with the 8RDA+. The only new part is a Fortron 350 PS, which worked fine when I tested it the other day. (Amazingly quiet with the 120MM fan!)
Facebook
Twitter