• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

7950 past 1.3V

M

mariokiller64

Junior Member
Can it be done? MSI Afterburner shows I can't go higher than 1.3V; and at a core clock of 1250MHz, it shows artificats. Benching right now at 58C with a water cooling setup. Wish I could increase the voltage more than 1.3 :twisted:
 
mariokiller64 said:
Can it be done? MSI Afterburner shows I can't go higher than 1.3V; and at a core clock of 1250MHz, it shows artificats. Benching right now at 58C with a water cooling setup. Wish I could increase the voltage more than 1.3 :twisted:
Click to expand...

sapphire trixx allows to go beyond 1.3v.
 
I wouldn't want the core to go a lot beyond 58c anyway with extreme volts/oc

My arctic setup doesn't go a lot above that either.

Besides, irrespective of temp anything beyond 1.2V over long term will kill your card, chances are sooner than later.
 
Trixx or ASUS GPU Tweak (if you have an ASUS BIOS I think) will take you to 1.4V. However after 1.3V your chances of permanently damaging your card drastically increase, even for short benching runs. Temperature plays an important protective factor here.
aaksheytalwar said:
Besides, irrespective of temp anything beyond 1.2V over long term will kill your card, chances are sooner than later.
Click to expand...
AMD's new boost cards run 1.25V default. Up to 1.3V is perfectly fine for 24/7 use as long as you keep your temperatures in check.
 
MrK6 said:
Trixx or ASUS GPU Tweak (if you have an ASUS BIOS I think) will take you to 1.4V. However after 1.3V your chances of permanently damaging your card drastically increase, even for short benching runs. Temperature plays an important protective factor here.

AMD's new boost cards run 1.25V default. Up to 1.3V is perfectly fine for 24/7 use as long as you keep your temperatures in check.
Click to expand...
So even if temps are low and voltages are high, I still pretty much have a high chance of damaging my card after 1.3V, huh?
 
mariokiller64 said:
So even if temps are low and voltages are high, I still pretty much have a high chance of damaging my card after 1.3V, huh?
Click to expand...
Yes. The reasons chips die when we push them in overclocking is electromigration. Things like current, voltage, frequency, and heat all contribute to this. By improving cooling we can get more leg room with voltage (and therefore current), but only to a certain extent. Unfortunately things start to degrade exponentially at a point, and on average that's around 1.3V for the 79xx chips. Of course, each chip is its own, and some can go further and some can't even hold at 1.3V.
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top