I would, uh, go out on a limb here and suggest perhaps the 5V line of your power supply. I think it's the red wire on any molex connector (black is ground, yellow = 12V, I think?), but I'd check on that before wiring anything.
I was just confused because this drive came out of a gateway, and they had a totally different power connector on it. The drive clearly states 5v, so I was just trying to figure out why they didn't just use a normal one, so I was reading too much into it.
And yes, I'm sure I own a store. I just usually don't need to care about how much voltage each wire carries.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.