3800+ x2 "windsor" + 2x512mb Geil ultra 800mhz

[marko29]

Hi all!

I upgraded my config from 939 to am2, my motherboard is an asus m2n-e.
the x2 3800+ runs at 10*200, the geil ultra 800mhz memories 5-5-5-18 2T 800mhz as default.

I tried the fsb at 220, it worked, and it also worked at 240 fsb, but this time i changed the rams from 800 to 667mhz, becouse i have no idea how the change the ram timeing, i've never had ddr2 memories, just ddr in the last 6-7 years, so i'm a beginner at this time.

Somebody could tell, that how big voltage i can use at the processor, and how to change the ram timeings when i raise the fsb... i hope someone has the same memories...

i flashed a newer bios , 802 instead of 602 which was in motherboard originally.
Can this be a problem that 802 is worst for overlocking that 602?

 

[myocardia]

There are only two differences between DDR and DDR2: it runs faster, and it uses less voltage. If this is your RAM: link, then up to 2.3v is covered under your warranty. And use this page to figure out the best way to configure your overclock: Gogar's A64 OC Optimizer.