2x1gb Crucial Ballistix in ASRock 4coredual-sata2 r2.0 will not POST

[pavelb]

Hello everyone, once again I come here for some opinions.

I've been fighting to get a pair of 1GB Crucial Ballistix sticks to work in the 4coredual-sata2 board. The board previously housed 2x1GB Kingston PC2-4200 RAM and worked fine. I've swapped the Kingston sticks with the Ballistix to my main machine because of the 2 kits (4 sticks total) of Ballistix, two have become pretty unstable and the PC won't complete POST with them in.

So, onto the two "healthy" Ballistix modules. Let's call them sticks 3 and 4 (as that's what I've labelled them physically with tape). ASRock mobo PC boots with no issues with stick 3, memtest86 does 20+ passes, prime95 stress passes for 12+ hours. Stick 4 will begin POST, but will not complete it. The PC halts at:

Press F2 to run Setup
Press F11 for Boot Menu
Single-Channel Memory Mode

Putting in both sticks (3, 4) I get a similar incomplete POST:

Press F2 to run Setup
Press F11 for Boot Menu
Dual-Channel Memory Mode

So, task #1 is to get stick 4 to complete POST. This is where I'm stuck, I've tried playing around with the settings in BIOS; unfortunately ASRock doesn't give you the fine controls I'm used to in Gigabyte or MSI boards when it comes to FSB sync or voltage (though the RAM timings are all adjustable!), so I'm stuck adjusting the following:

DRAM Frequency: [Auto, 266MHz (DDRII533), 333MHz (DDRII667)]
DRAM Voltage: [Auto, High, Normal, Low]

I should mention, this PC I'm using as an HTPC is running an E5200 at stock (200MHz x 12.5 = 2500MHz).
I can post more available BIOS settings, if need be, but any suggestions are appreciated. I have tested stick 4 in the other PC with memtest86 and prime95 and it seems to run OK in the GA-P35-DS3R board I have here.

Thanks.

 

[pavelb]

New developments:
Flashed the board with custom BIOS 2.20a.
Board boots with stick 3+4, just stick 3, or just stick 4.
In both cases where stick 4 is present, it only registers for half of its capacity (512MB).
Memtest86 fails immediately with 3+4 dual channel config.
Memtest86 is currently running strong with just stick 4 in with 4 passes completed.
Any configuration involving stick 4 will not boot into Windows -- the screen goes blank, and the OS stops loading just before the Windows logo. During this the machine is responsive -- to the extent that pressing NumLock/ScrollLock/CapsLock changes the corresponding keyboard LEDs.

Testing will continue before I RMA all the sticks.

 

[daRkKon]

crucial ballistix ddr500 for platform 939 are you talking about?

 

[lupi]

there's a reason I have 4 1gb ballistix modules sitting in a box on the bookcase waiting for me to one day rma them.

 

[pavelb]

crucial ballistix ddr500 for platform 939 are you talking about?

RAM is not dependent on CPU Socket type - if you are referring to AMD's Socket 939. This is an LGA775 board at any rate. The sticks are rated DDR2-800.

In other news:
Memtest86 is passing. Windows is not booting. Time to shell out for HCI Memtest Deluxe for further testing.