I'm trying to run two displays off a PC through a KVM. Display 1 works but display 2 gets no signal. As soon as I unplug display 1, display 2 pops right up. If I plug d1 back in it goes off. Computer 2 works fine with both displays.
It's a complicated setup, so here it is:
Both computers are running video out to TWO KVM switches. Both Startech. One is a standard two port running the DVI dual link. The second is a new startech running display port MST 4k at 60hz
Computer 1 has a nvidia 660 gtx
Computer 2 is some sort of quattro - I think a k620.
Display 1 is a Dell 3007 running at 2560 x 1600 over DVI.
Display 2 is a Asus PQ321 running 4k @ 60hz over display port.
I first had a nvidia 970 from gigabyte on computer 1 - it's kinda odd with 6 ports. I found some poor documentation that only 4 ports could be used, the others would shut off automatically. I figured that was what was happening so I swapped to the 660.
Am I missing a setting somewhere?
It's a complicated setup, so here it is:
Both computers are running video out to TWO KVM switches. Both Startech. One is a standard two port running the DVI dual link. The second is a new startech running display port MST 4k at 60hz
Computer 1 has a nvidia 660 gtx
Computer 2 is some sort of quattro - I think a k620.
Display 1 is a Dell 3007 running at 2560 x 1600 over DVI.
Display 2 is a Asus PQ321 running 4k @ 60hz over display port.
I first had a nvidia 970 from gigabyte on computer 1 - it's kinda odd with 6 ports. I found some poor documentation that only 4 ports could be used, the others would shut off automatically. I figured that was what was happening so I swapped to the 660.
Am I missing a setting somewhere?
