2100+ @2700+ on default vcore???

[FFactory0x]

Hi i bumped it for a little but downed it to be sure

I had my 2100 @ 2400 on default and it was fine 11x166 with mem 6332 (512 pc3000)
Can i keep it at default vcore and up multi to 13x166 at those timings?
BTW at 2400+ i think my as3 has kicked it cause my cpu under full load is reading 31c and 29 idle.
Plus i have 5 case fans + ps's fan and sk-7 with ys adjustable on full
Sounds loud as hell but i were headphones so no problem.

 

[dannybin1742]

run your mem at 5 2 2 2t, you are running it below spec anyways, you should be able to lower the cas timing

 

[Megatomic]

I have to up my Vcore to 1.65V when I run at 13x 166MHz (8RDA+/2100+ Tbred B). Also, my Kingston HyperX PC2700 runs at 2-2-2-5 when in dual channel mode. I think you should be able to pull this off as well.

 

[FFactory0x]

does it matter what bank it is in. I believe mine is in bank 3. Just stuck it in 2 weeks ago and didnt think it mattered

 

[Megatomic]

I have mine in 1 and 3 as well. I've heard that this is the recommended config. for dual channel on most nForce2 boards.

 

[FFactory0x]

i have 1 512mb stick. Also i looked at googlegear and the spec says. 6222. Will i see a difference between thatand 5222 or 6332

 

[Megatomic]

I saw a difference of about 100MB/sec when going from 6 to 5 on my 8RDA+ using PC3200.