2 bh6 and 2 p3 slot cpus

[oslama]

the mother board is version 1.1 and supports upto p3 800 and 1/4 divider.

i can run my p3 700 at 933(133x7) but when i put a p3 667 (133x5) it defaults to 500.

i also have a version 1.01 (no 1/4 divider support) that can runs the p3 700 at default speed.

do i have the correct settings for the 667?

 

[oldfart]

<< the mother board is version 1.02 and supports upto p3 800 and 1/4 divider. >>


Actually, it will support well over 800. You can put a 1.1 Gig in it. Be sure you are on BIOS rev SS. The 1.02 has the 1/4 setting in the Soft menu? I thought that started in rev 1.1. What color are the rear ATX port connectors? Are they colored, or all white?

 

[oslama]

its the newer version 1.1 it has the updated (fsb upto 150) bios

the older version can run both cpus at spec. speed but the newer one has posting problems, on auto settings it defaults at 366 but when i manual change settings it defaults to 500 on both cpus

i want to put the 667 on the 1.01 at default w/viper II videocard and the 700 on the ver 1.1 running it at 133 (maybe 140) x 7 w/ geforce2.

 

[oldfart]

The 667 on the 1.01 will be a problem. !33 FSB and a 1/3 PCI setting gives you a 44.3 MHz PCI. Not good. The multiplier is locked @ 5. You can run it @ 5 x 112 for 560 Mhz. Set up the BIOS for user defined, multiplier 5, bus 112, agp 2/3, speed error hold disabled.

For the 1.1, Set up the BIOS for user defined, multiplier 7, bus 100, agp 2/3, speed error hold disabled. CPU voltage default.

If you want to overclock the 1.1. raise the bus speed. I'm not sure if your 700 will do 933. You will likely need to increase the voltage.

 

[oslama]

i have run the 700 @933 on the 1.01 but the geforce 2 cuts off in couple of minutes during gaming

that why i got the 1.1 so i can run the geforce2 at 1/4 divider.

oh well as long i can get more mhz's and fps's.