Question 1G Fiber in home

mannsan

Junior Member
Apr 14, 2020
1
0
6
Hello,

I just got 1G fiber installed in my home. The modem/router that was left when they installed it had to be put on one end of the house. It had to be put there as that is where the office is which I am hard wired with a network cable with 2 laptops (one for me and one for my wife) and 1 Cisco IP phone. The issue is that now the wifi is not strong on the other end of the home. When they installed the internet they hooked up other coax inputs to the box in my closet. They then put that modem/router in the office. I have a few questions over this.

1. I have another room at the opposite side of the home with a coax jack and network plug. Can I plug in a 5 port un managed switch to that network port and I will have internet from there to connect other devices? Or would that network input not have any internet connection?
2. would the coax jack in that other room have an internet connection and I could plug in another modem/router on that side of the home?
3. would it make more sense just to get a wifi booster and put it in the middle of the home to extend the wifi to the other end of the home?

Can I have some recommendations on what is the best route good gear that would work best for what I am looking to do?

My goal is to get a good signal on the other side of the house as it is weak. I want to keep it as simple as I can but ensure I have a good connection and it works.
Suddenlink is my ISP , 1G fiber, Coax connection to modem/router
Devices 2 macbooks, 1 apple tv, firestick, ipad, 2 iphones, google home, sonos speaker, echo dot, smart thermostat, ring doorbell
 

VirtualLarry

No Lifer
Aug 25, 2001
56,587
10,225
126
Is SuddenLink, a cable provider? As in, your service drop (ultimately) is provided by a Coax drop to the home, and a DOCSIS 3.0/3.1 modem or Gateway?

If so, I don't think that you can use a Moca extender like you could with Verizon FIOS, or another cable modem off of the drop, without a second account at that address (at least, that's the way it is with Comcast).

Consider a Mesh wifi networking solution?

Is you home wired with ethernet drops to all of the room? Do they all end up at some wiring closet / central location? If so, then there are some definitely possibilities there.
 

Fallen Kell

Diamond Member
Oct 9, 1999
6,228
543
126
I think even if the home is not wired up with ethernet to a central location, I would suggest having 2 ethernet cables run from the office to a location in the middle of the house. I then suggest using one or both those runs to extend your network to a wireless access point in that central location (or put your wifi router in the central location using one of the 2 ethernet cables and use the second cable to connect back to the office from the LAN side of the wifi router to a small network switch to drive the equipment in the office).

There are plenty of companies out there that specialize in installing network drops in a home/small office. For something this simple, it would probably not cost more than a couple Benjamins (well might be an issue covid-19...). You can also try doing it yourself depending on your home (easy basement/attic access can make doing it yourself very doable with $40-50 of tools/parts for 2 low-voltage wall boxes (one for the office and central location), 2 wallplates with 2 ethernet connections, a wire fish tool, and a spool of CAT6a cable).
 
Last edited: