Recent content by Ytru4u

  1. Y

    ram/psu overclocking

    nice link bonzaiduck, lots of good info.
  2. Y

    Looking for real nice HSF..

    nice, you also might look into a thermaltake they also have very good if not the best HS and have the choice of puting any fan you want onto it. good hunting
  3. Y

    L12 mod

    lots of good info thx for the help people ytru4u
  4. Y

    L12 mod

    will try to look for a jumper om my MB if there is even one on my ABIT AN7
  5. Y

    L12 mod

    good ideas, but i can not even get it to post so that i may change in the bios
  6. Y

    L12 mod

    well when i got the cpu and pluged it into my abit an7, i got a code that says "failed overclock". now i dont know if he tried to overclock it but this code says failed overclock. after reading a lil about the L12 mod, i was not sure if it could apply to a more than likely dead cpu
  7. Y

    L12 mod

    just got a dead cpu form a friend that did not OC his 2400 right. my question for every one is: would a L12 mod work on a dead cpu?
  8. Y

    Stumped - Mobo Issues - Erratic POSTs

    Sounds like you can get to doing things when you reboot, witch makes me think that the cpu is cooling down enough for you to do things then it gets hot and stops working, I do not know much about the mother board that you are using but it might have a fail safe that if your cpu gets to hot it...
  9. Y

    how to remove picture at boot

    use extreem caution when doing it this way
  10. Y

    wacky hard drive setup

    make sure that the jumpers on the 2nd harddrive, the one you got form your friend are set the slave, ohh and you might have to set the jumper on your primary master to master with slave.
  11. Y

    win explorer problem - win2k

    I would agree with gordanfreeman, it is always good to up date the os/drivers. this would be a good place to start.
  12. Y

    ahhhhhhh... my poor puter....=(

    dont just try to pull out one pull out all and try with a good stick in, one that is in a computer that is working with no hang up, also like another persons said try to switch the order of them. do it the cheep way, no need to go and buy a new stick unless you know that this is the problem...
  13. Y

    fried a Sapphire Radeon 9500 pro. Anyone good enough at soldering?

    my bad, over looked it some how.
  14. Y

    fried a Sapphire Radeon 9500 pro. Anyone good enough at soldering?

    will a rma cover somthing like this?
  15. Y

    ahhhhhhh... my poor puter....=(

    Had something of the same thing happen to me, after days and days and many reformats, changing of hardware it all came down to the memory. I pulled a good stick out of another computer and started with a new install of XP and no more hang ups or loop backs. Now if I would have tried this before...