Recent content by Windancer

Thanks for advise, but same results. Dumb question, but this is referred to as Dual Channel Pack....I thought a matched set. But is it compatable with Socket 754 boards? I am reading that only 939 are dual channel capable.

Search on PQI doesn't give many hits on this forum, so may not be popular brand. Memory below will not allow the socket 754 DFI LanParty board to boot at all...with either 1 or 2 sticks in any combination of DIMM slots, basic BIOS configurations....no tweaking. Board will boot and run fine...

Did buy new from NewEgg....this particular board is only supported by manufacturer (can not get the NewEgg "insurance"). Will contact DFI in morning and see what they can provide. Downloading manual now...the one that comes with it is just for quick startup...hopefully the download version...

Yes sir. That is the board.

Have tried your suggestions without success. I can't believe I just trashed this board...have not had it 24 hours! this has not been a good day. What is involved in CMOS replacement? I can not tell if it is socketed or not...it does not appear to be surface mount. I guess to the FS...

Flashed the N32LD128; completed ok. Hit F1 to reboot. Hit DEL to go to SETup. Set optimized settings. Saved. Now just a beep every few seconds. Blank screen. What did I do wrong and is there a way out? TIA...David

PSU is Antec 380W. I will install Memtest86. Thanks for input.

Hello....Had trouble with OS installation and loss of network on DFI LP nF3 with A64. System: DFI LP UT nF3 250Gb w/ A64 3400+ ZalMan CPU cooler LG DVD Floppy Matrox Graphics card (using this till my new card arrives) WD 120 IDE?.this is one I am installing to 2 x Maxtor 120 SATA...

There were 5 remaining @ the HD near Beltway 8 and I-45...Houston...as of this morning.