Recent content by Wez

I have the M1A on my PAL 8045T overclocking an XP1700+ thoroughbred RevB at 2004mhz...temps are 34-36C idle and 38-42C at load(using Prime95)...ambient 21C and case 25-26C I had the Enermax Temp Controlled fan on there at below 2000rpm and very quiet running the proc at 44C under load...the PAL...

Acts837, I would do an analysis of the NMBs, but I have not tried them. I imagine this are very similar to the PC Power and Cooling. I have noticed that the L1As do have some kind of noise, but I don't believe that it's bearing noise. It just seems like that's the sound they make when they...

I recommend the Enlight 7000 series. It's little more expensive(60 shipped at newegg) but has alot of good features like drive rails. It's also easy to get into and out of.

I just installed my Nexus NXP.101 today. I believe you are looking at the 201. Here are some observations in case you want them: 1) LCD panel is weak. Cannot be viewed from angles, must be head on. 2) The rheobus makes a slight high pitched sound. It's not very noticeable unless you have good...

having tried about 4 different kinds of fans, here is a mini-synopsis: Note: Except for the Thermaltake Smartfan2, all these fans are around or below 29db, thus are better than your normal fans. Quietest: PC Power and Cooling 80mm fan. The Good: Very quiet, and low turbulence noise The Bad...

I installed my Throroughbred B JUIHB 0302 a couple of days ago and I've been searching for the max speed for a couple of days now. After running Prime95 and 3dMark2002SE, I've pretty much maxed it out at 11X183 for 2004mhz at 1.700V(though ASUS Probe reads 1.744V). at 11.5 X 180, I get a...

okay getting you down for three tubes...so far, 10 tubes...need 40 more...

LOL...now that is funny =p

NM...I got it...heh heh...noobness

LOL...how do you get links in your signature????

hmmm...can't see the thread Wiz... what kind of cooling are you running it with and what temps are u getting? I'm probably going to be using an Agilent Arcticooler w/ asIII. I'm sure that the PCI bus will be the limiter here. Average o/c speed on overclockers.com cpu database is 1526mhz with...

got enough to get a new 1.1A but didn't cover the converter costs. However, the 1.1A and prospect of o/c to 1400mhz range got my system sold too...so all in all, a very good deal! (of course, I was selling the system to a friend so I sold it for cheap as well...lol...I'm glad I don't run a...

So-Tricks has pretty good deals on the Panaflos and other stuff as well...the H1a that they sell have rpm monitors!!

evidently, I did sell it too cheap...oh well...

wow...there was really high demand for this proc...I just sold it in less than 15 minutes.