Recent content by Tog

Good Afternoon All, Long time no post. I received my Zen and like the others....like new condition. I have read concerns about drag and drop so here is what I have done so far. I am using Win XP sp2 OEM. When you put the installation disk for Zen in cancel setup if it auto runs. Pull up...

Just ordered one! Thanks!

Well, WooHoo MSI just e-mailed me a rma request form to fill out. Thanks for the replies.

I e-mailed their msirma. Took everything loose on the board except vid card,cpu,ram still nothing even changed batteries on motherboard then swapped out power supplies still no go. So, had an old board and swapped out boards, the beast then booted right up so I am pretty shure it was the board...

I built this system for my dad back in October 2000. The Board MS-6330 K7T Pro, Bought from Paragon-Tech out of Manhattan, KS, Has died. No post, no beeps, all red LED's, no nothing. The problem is it seem's Paragon has gone out of bussiness. I can't reach their web site and I can't reach them...

I have a lucent win modem will that setting work the same with it?

The driver came with the modem which was new. Modem installed correctly and configured in control panel so I don't understand it. Could just be a bad modem or maybe I am missing something?

Well it is a brand new system modem has never been used. Could have been a bad modem to start with though. Tks, any other ideas?

I tryed AT&T and got the same message.:(

I am running win98se with a pci win modem. Device manager says modem is working no conflicts. Was trying to set up AOL and I get this message that I do not have a dial tone. So I unplug phone line from modem and plug in a telephone. Phone works,get a dial tone, so I'm clueless. Anyone have any...

To check the bindings right click on network neighborhood go down to properties. Go to TCP/IP double click- there should be a tab called bindings check to make shure all bindings are bound to the other computer whatever your protocol. check each protocol the same way (ie. netBeui, Ipx/spx ect.)...

Check to make shure that the bindings on both computers are checked for the same protocol.

Your monitor can not be defalt monitor must be your monitor or plug and play.

a

a