Recent content by tkkidd3

  1. T

    frys b&m,: e8400 and gigabyte ge-ep43

    Ga-ep43 are good board. with e5200.. i overclocked it at 3.75..+ with ep43.. north bridge was a bit hotter side.. but i did that with minimal tweaking. this board also does not have firewire. and raid.. i think it is a good deal
  2. T

    help - ep45-ud3p

    ep45-ud3p version 1.6 lastest bios fb motherboard + power supply. 24 pin and 8 pin. plugged in 700w power supply. 9800 evga low power edition. ( which required 18 on 12v rail. which i have) pluged in one sata drive on sata0 connector for front cables.. just speaker and...
  3. T

    Gigabyte EP45-ud3p

    ep45-ud3p version 1.6 lastest bios fb motherboard + power supply. 24 pin and 8 pin. plugged in 700w power supply. 9800 evga low power edition. ( which required 18 on 12v rail. which i have) pluged in one sata drive on sata0 connector for front cables.. just speaker and...
  4. T

    help - ep45-ud3p

    memtested it with diffrent board. i set the manual timing and voltage. i even loosen up the timing and up the voltage.....
  5. T

    Gigabyte EP45-ud3p

    I can't even get to the post page. i just hear a long beep.. thought it was power. but it just won't boot. I tried yello slots and the red slots. can't boot when there is a two dimms
  6. T

    Intel Matrix raid 1+0

    Intel10R southbridge chips come with Intel hybrid raid... call matrix mode. it's able to do stripping and clonning with just 2 hard drive. I have been looking for a review, But i haven't had a luck. Any one using this? Pros cons? THank s Moved to appropriate forum -...
  7. T

    help - ep45-ud3p

    spec. ep45-ud3p intel e5200 800 ddr2 ballastix 700w cool max power with 8 pin connector. 9600 gt low power edition. I can get it to boot with single channel mode 2 X 2gb in bank 1 and 2. but 1 and 3 / 2 and 4 for sual channel does not work. i tried setting the v volt...
  8. T

    ASRock P45XE vs Gigabyte EP45-UD3L

    i tried ep45-ud3p.. i could not boot with dual channel mode. it worked fin in single mode. tried 2 diffrent board. i just don't have enough patient to tryt he third.
  9. T

    Gigabyte EP45-ud3p

    I'm lucky. I live by fry's. So I get to play with all the toys i want before i make up my mind. I have not built a system in a while... but i had a e5200 sitting around so i start building a system. the first Mb i tried was ep43-ud3l. Northbridge was running hot, but I overclocked...