Thanks LTC8K6,
I tried getting the answer from the ARTEC site before and ran into the same scenario.
LOL! Would you believe the only faq that's not coming up is the one I need? LOL! All the other faqs work fine. Just my luck. Hopefully I will here from someone soon.
Hello all,
I'm working with an older scanner which is an Artec AM12E. It was working fine for my relatives before but now, when they try to enable it, the following error occurs.......
"fail to adjust to an adequate color balance value"
Does anyone know how to troubleshoot this...
Hello all,
I've been running the new Omega Cats since yesterday and I've experienced no difficulties. Omega is awesome! I've been a fan of his work for a long time. It's a shame that Nvidia is giving him trouble. I use his drivers for my good old TI4600 and his tweaks are definitely a plus...
chsh1ca and Fluxcap have a very good point.
I spoke with some friends of mine about your video issues and we've all come to the agreement that you may have a bad card. I wasn't sure before because I've seen this problem rectified on other 9800 Pros but you've done so much and you are still...
Wow! So many configurations without positive results. Hmmm. Hang in there niteshadw. Try this config. Go into your BIOS and see if your video cache is enabled. If so, disable it. If you have a UC and USWC option, choose UC. If your graphics are still corrupt, uninstall your video...
How many watts is your power supply? The manual says the bare minimum is 300 watts but it's best to have 400 watts or more. Your CPU alone will take approximately 80-90 watts. Is the fan on your video card working properly? What OS are you using? Check your BIOS again because most boards...
Hello all,
If you're at your desktop,
Right click
Scroll down to properties
Click properties
Click the Settings tab
Click on Advanced
The "Alternate Pixel Center" option is within the Direct 3D Tab. But the defects you're showing would not be cleared by that option. Your BIOS may not...
@ SmuvMoney
I could not have written a better reply. Your reply for 1ManArm Y is very detailed and very well written. Your post will not only help one person, it will also help many.
Take care.
Hello all,
I went through a scenario similar to this one. It happened when I enabled 8X AGP. The visual defect went away when I increased my AGP voltage from "AUTO" to 1.7 in my BIOS. I also have the "Alternate Pixel Center" which is found in the ATI Propeties enabled as well. I no longer...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.