Recent content by TheCrazzyman

hehehe yeah but i was gona go redudant. that would have been 250_300$$$

heh sorry about that last post( if it showed up) what i used to do is i got a PCI vidcard and put it in a PCI slot (duhh) then you set up the drivers and configure the monitor config and it should work. i used some crappy matrox old card with like 4 megs of ram. it worked but one of the main...

im going to try and go to kompUSSR and getting this PSU. its 20$+, its one of thiese TruePower True550 ATX here is the linky here im going to get that today THANK YOU GUYS VERRY MUCH

ok just checked the voltages with the bios and a volt meter 5V 5.34 AGP 1.52 sorry about the first set of voltages. thoes were off the top of my head from when i looked last time

damm fast reply hehe its a raidmax 400w ill check the V in one minute the modle is PM-S400W

ok i had a chaintech ti 4600 and when i would play games ANY GAME or benchmark. so i tested my card in my friends comp and it worked FINE. so then i found some one to trade it with for a nother 4600. so i did and got a gainward 4600. so i get it in my computer and try and play.......and guess...

hehehe thx i didnt see that Online part. ill find that # and call them. Thank You

this is what i get "Request a Return Materials Authorization Number This group of products is not supported by the on- line return process." WTF!!!!!!!!!!

that is what i thought. let me do it again and ill post what it says

ok i got my new 80$ 3COM NIC and the clip broke off that holds the cable to the NIC. so i go to 3COMS website and register my product, then i wait a coupple of days as the email sayd. then i went back to there website and they sayd that they dont offer a RMA on that class of proudcts...

i made my own. but then ran out of room and bought a diffrent one off ebay. that is a good place to look. and its simple to make one all you need is some 90degree 1" angle-iorn and a welder, then have some fun! it only took me about 2hours to make it all up.

ummm in 2k adv. server there is a setting in the ICS settings that you can allow a port like 21,27015 and then it asks you for the ip of the computer that is runing this service. that should do it...... but thats in 2k ADV. server so

ok i donwloaded clark connect but im having trouble. i got evertying setup and i just cant get it to get an ip from my modem. so if you have any ideas please post. Thank You

i dont think att blocks port 80, well the dont for me. so far for me they dont block any ports(that i know of) i run a mail server, web server, ftp server, game servers.