Recent content by Technonut

Sweet OC..... :thumbsup:

Quad action.... Sweet.... :) If I did not already have this X6800, I would be all over the QX6700. ;) Duvie: Once you get your OC settled, make some AutoGK runs and post the results...

Funny... I have been running @ 3.7GHz 24/7 for quite awhile now. (watercooled) ;) If you take the time to click the link in my sig, you can see my imaginary 25 hour Orthos run. :) Duvie and Markfw900: If you have not noticed, this forum has much changed over the last year or so, and...

Shortly, I will be departing for a 25 step run to the oven to celebrate Thanksgiving. Afterwards, another brisk 5 step run to my Lazyboy......:P Seriously though.... Bateluer, it is great for you to spend the Holiday participating in a good cause. :)

I just threw a X1950 master card in my rig to go with the Viper X1950XTX I had, enabled Crossfire, and scored 11,529 in 3DMark06.... :)

Botched audio driver installation? EDIT: Play an MP3 while watching Processes in Task Manager to see any unusually high usage.....

Be sure to post results.... :) Personally, if I decide to jump ship with the P5W DH, I more than likely will go with the ASUS Striker Extreme.... ;)

What is the processor usage on both cores during encoding with NeroVision Express? I know that DVD Santa runs between 70-75% for me.

More than likely, your RAM is not stable..... Run Memtest86+ to find out.

One could pop $299.00 for This NVIDIA Mini-ITX mobo..... ;) Throw in a Turion, and you could have a pretty bad-ass (but expensive :Q ) Mini-ITX secondary in the Mozart TX. BTW.. I have the Mozart TX, and am getting ready to throw it together with some watercooling goodness. :) It is a...

What are you using to read temps with Lou?

Nice rig in the works.... :) I have been the VapoChill (PE) route, and have since retired it in favor of good watercooling gear. ;) Just be sure the mobo is compatible with starting the LS, double check your insulation job, set the clamshell heaters properly, and you should be golden...

Try lowering the FSB and raising the multiplier.... I knocked mine back to 264, (264.5 CPUZ) and raised the multiplier to 14 to run 3.7GHz. I had the RAM timings @ 5-5-5-15 when dialing-in the higher multiplier, then went back and tightened them up after I stability tested the processor...

Nice OC...... :)

Why not?.... It does not take much effort if your rig is stable... ;) Like this: 3.7GHz 25 Hour Stability Screenie Now, off to tighten up those pesky RAM timings some.... :D