Recent content by Supertex

In winxp pro... in administrative tools, look up your "indexing service" make sure that its on manual, and not automatic. That will make your drive run ALL THE TIME.

If you are using a KR7A, you can use WPcredit to alter the bios halt commands. That will be good for around 25 degrees F. Changes are as follows: 92= E8 (from68), and 95=1E (from1C). I have the pcr file if you want it, but you dont need it to do this. Tex

No, you wont hurt it at all. That is what my cpu stays at now. Those low temps in prior posts are what this cpu ran on my KT7. I too was complaining about the high temps with this KR7A ( and the winbond HM ). With the case open, it actually drops to 50 C, but that still sucks in my book. 55...

Hynix is the chip manufacturer on the OCZ pc2700 that I have.

Well let's see, my case is good. It is the "hydraulic" Antec model, with a 50 cfm 80mm in the front and a 7k rpm 60 mm in the back. I cut out the MB tray behind the cpu, to facilitate airflow behind the CPU, avoid reflecting heat back onto the MB, and enable the addition of the Alpha type...

It's here! It's here! (dances a jig) My Corsair XMS2400 has arrived!!! (May have to take off early!!!)

Actually, I havent had it long enough to remember what chips are on it, although I have looked. I am at work right now(real busy huh?) but when I get to the house, I'll see. Now I'm curious too. You have any input on the temp situation I have, or how to get the VIA hardware monitor to work on...

I'm sorry man, but the only way I would slam it more, is in a car door. I am aware of its origin, but that doesn't change the fact that it is inferior to the likes of Corsair, and Mushkin; which, by the way, I was unaware of until coming across this forum. Only then did I notice that NO ONE...

Oh yeah, how in the hell do I get rid of the winbond hw dr. and re-implement the VIA hm? I HATE the winbond prog. I want degrees F not C. Am I stuck with the winbond BS? I'd put it right below OCZ ram ! ! ! ! ! Tex

Well Taz...you were right. OCZ just took pole position on my sh*t list. PC2700 is junk sh*t, and should only be used as a bookmark. I ordered 2 128 sticks of Corsair 2400 cs2 I hope that brings the potential of the board around. I can't run the 2-5-2 settings, it wont boot to windows, and I...

I want to see how high the bus gets with the settings jacked up as high as the ram will allow. That is where the "make or break" will be, as far as I am concerned.

So I see you are using the ASUS? How about the divider on that one? Will it go over 4:2:1??

He is using micron pc2100 / 256mb. Now I wonder why I bothered with the $69.00 PC2700? Hell, for that matter, why would anyone??

I am real curious about your bios mem settings, AND the new sandra. Really, your mem results should be higher for that FSB, even at 8X. And I am amazed that pc2100 will accomodate that speed. I just bought a week 22 AYHJA - Y 1.33, a 256 of "pc2700", and a 550 enermax. I was about to order...