I know software reporting for PSU voltages are usually way off but SpeedFan is showing the following voltages
vcore1 : 1.12
vcore2 : 1.87
+3.3 : 3.36
+5 : 4.95
+12 : 2.56!!!!!!!
-12 : -16.64
-5: -8.27
+5: 5.11
Vbat : 3.09
I tested one of the Molexs and its showing 12.25V so that...
Hello,
I recently purchased a Zalman 160XT HTPC case and I am not impressed with the fan control software included with it. I would much rather use another software with more options and also one that provides control over all fans connected to the controller. The stock software is only...
Thank you for the reply. I install the driver through nVidias program which I allow to install and then reboot my machine. When my machine comes back up, it says it detects the hardware but can still only identify it as a VGA controller and can never find the driver. I have had no luck in...
Can someone pleeeeease help with this. I have had no luck locating the drivers for this PCI card and I have had no response from Chaintech on this matter.
AdamR
Hello All, I have purchased a Chaintech Nvidia MX4000 PCI card to use for a third monitor I would like to use for system monitoring. The system detects the new hardware but will never let me install the drivers for it.
My specs are as follows
Asus A8N-SLI Mobo
1x 6600GT PCIe
1x Chaintech...
It actually hasnt happened again and it had happened 3 times in a row since I had written this. I think the problem is with the Keyhole sat image viewer?
According to SpeedFan, my voltage values are as follows :
Vcore1 = 1.41V
+3.3V : 3.25 (OK)
+5V : 4.94 (Little low)
+12V : 11.78 (little low)
-12V : -1.75 WTf?!?!?!
-5V : -8.78
+5V : 4.92
I have been experiencing some system lockups recently where my right monitor will go blank and...
OK, I have installed the card and its recognized by windows but I am not getting the BIOS screen on bootup. Is there anything else I have to configure?
AdamR
I saw the 3ware 8-port card and it was like $600 compared to the highpoint 8-port card.... Ill take the performance loss for 1/3 of the price.
Now, as soon as my software RAID5 array is done "Rebuilding redundancy" Ill go ahead and install the highpoint card I have sitting here.
Wish me...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.