Recent content by SirGameAlot

Thnx i will give it a try.

I have a Amd Athlon 1.33Ghz with a MSI K7T turbo motherboard. I have the latest Bios upgrade(2.7) but don't know how to put my mobo on exactly 1400Mhz. It probably has to do with the voltage and stuff like that, i can get it at 1394Mhz but never on the smooth round figure of 1400. So if anyone...

Remove your heatsink and processor core from the motherboard. Underneath the processor plate (on the Mobo) there should be a small brown flat cable. This is the temperature sensor, it touches the processor and measures the temperature which you see in the bios. Check to see if it makes contact...

Hello, I have two maxtor 30.7 GB ATA100 drive, one at 7200 rpm and the other at 5400rpm. Will I be able to use RAID?? Greets

Look at the back of the disk, there should be a jumper there. Place the jumper in the correct place and voila. Greets

Hello, I have an Microstar K7T Turbo VIA KT133A chipset motherboard. This has the onboard RAID controller on it. I have the following questions : 1.Is it hard to set up properly (bios, windows, control panel, ...???) 2.How do I configure everything 3.Are these two disks OK for using the RAID...

Hello, I have an Microstar K7T Turbo VIA KT133A chipset motherboard. This has the onboard RAID controller on it. I have the following questions : 1.Is it hard to set up properly (bios, windows, control panel, ...???) 2.How do I configure everything 3.Are these two disks OK for using the RAID...

My opinion is when you have a fan in the front and one in the back is in most cases sufficient as long as you notice that your ambient temperature is being lowered. The cooler it is in your computer case the better for your processor when you want to overclock or increase the lifespan of your...

This is grayed out in my control panel. I knew about this but I dont know how I can get it to work so I can choose it. Any help would be much appreciated. Greets

Hello, I have three computers and have an urgent need to mount some good quality IDE racks with good cooling fans. I have to change drives many times from comp to comp and they get really hot and are increasing the temperature in my ATX High towers. There are so many hard drive mobile racks out...

Sounds fine to me, its actually quite cheap isnt it? Those fans seem to have little CM values or isnt this the value for the amount of air blown away??? I thought the higher value of cm the better?? Just a thought though! You definetely cant go wrong with that case! Greets.

Hello there, I'd defenitely go for the 300 W supply (Any will do actually) cause when you are planning on getting a highspeed processor you probably are gonna put a high grade video card in. (Not much sense in getting a lowgrade geforce when you have a faster then 1000Mhz cause it would be a...

Thanks for these hints and advice guys, hope it will work. Gonna apply some new paste and add some systemfans, one below my Geforce(PCI fan) and one in front of my case. been thinking about getting some Coolermasters also for my harddisks. Greetings

Hello, My geforce 3 was 60C and the DDR ram was 54C, smartdoctor told me this was OK for my card. Greets, gonna buy these fans today. Tomorrow I will return my comp to the store and let them see for themselves and try to solve this problem

Hello, Is this any good for keeping the air cool in my ATX 300W tower. http://www.pchertz.com/fc2000.html Or are there any better system fans??? Which ones are good cause now I dont use a system fan, never have actually. But now I am sorta obligated to do so because of my new super heat...