Recent content by shadd

Tryed bumping the (g)mch but failed when i loaded into windows so iv just changed the ram timings to 5-5-5-15 and lower the voltage to +.2v just to be on the safe side, speedfan is reading 2.06v which is ok. Lost 100 points on 3d mark though but still getting 14.8 seconds on superpi. Going...

Thanks for the speedy reply mate. I have version 4.33 of speedfan, 0.96 of coretemp and TAT V2.05 Yeh for it to run at 4-4-4-12 it says 2.1v but my orthos fails if i dont have +.3 at 3.6 oc unless i down the timings to 5-5-5-15 (much difference?). Regards

Hello lads, been following this thread and using it as a guide quite regularlly, so thanks first of all. Now i just have a few questions as iv not read every single page so you may or may not of gone over this but i just want some clarification/reassurance on my temps and voltages. Basically...