Recent content by Sao Paulo

I'm an ABIT VT6X4 user, and I have had absolutely no problems with this board no matter what I've thrown at it. The new BIOS update gives a decent performance boost but does not sacrifice stability. Considering that this is only the second BIOS update, I think ABIT would be a better choice...

First of all, try www.2cpu.com - a site dedicated to non-uniprocessor systems/components, and check out their reviews on various dual processor mobo's. If you are looking for a reliable board, then you should consider DFI.

Not really. The first one I bought was fried within two days, but thats because my psu and power bar units were faulty. I have been using it on a celeron 366, pushing it to 550 whenever I needed speed, and have noticed no anomalies with the board. Memmory performance is somewhat low compared to...

Chad, you must be gay. I want nothing to do with u.

I've been messing around with wpcredit and my via board, and under device 1 (PCI-PCI bridge) I found a few register settings that might help in increasing AGP performance. I have no way to test if my mods increase performance because my agp card is crappy and i use a voodoo2 for 3D, but anyone...

I'm looking for a proggy that can identify RAM, especially its latency, timings, etc. I have some NEC RAM but I am not sure if it is PC 100 or PC 133, and I need to be certain..

These WPCREDIT settings should work best for VT6X4 owners. Note: Use WPCRSET to set the registers in the following order: No. Register|Data 1...50|FF 2...51|FF 3...68|40 (for 66 Mhz PCI) 4...64|12 5...65|12 6...66|12 7...67|12 Set register 68 first before setting memory interleave (registers...