Hey guys I havent been here in close to 2 years as I rarely have time for computer stuff, even though I still love it.
I think however, that my KT3 Ultra 2 is dying....originally I thought it was the PSU was since the voltages were going but now I feel it is the mobo.
Heres the deal: My...
sorry, Expansion - i mean that you probably wont be able to upgrade or add components because it will be too much for the PSU to handle, also i recognize that the PSU only has 170W combined on the 3.3 and 5v rails, which is kinda of weak. I kno the 350W that comes in the SLK3700 (i have one) is...
hmm that combo is ok although it leaves no room for expansion and id just want to get a larger PSU just for comfort... many problems can be caused by cheap/weak PSUs.
Get a Panaflo H1A or something similar to put on top of the AX7.. from SVC id get a http://www.svc.com/convarspeedc.html tho. I...
Go with an Antec Case, i recommend the SLK3700 w/ 350W PSU, i tihnk its like $84 shipped on newegg, and still cheaper than ur case + psu combined
Go with some HyperX 3200 or 3500 ram since u will be OCing
Get a SK7 from SVC for $20, much better HS and cheaper.
Otherwise the choices look very...
well since ive been aware of computers, its been about every 2 years... 450mhz PII --> 900mhz Tbird --> 2100+ .. i wish i could do it more often but im 16 and saving for a car, so until that i cant get anything :( Hopefully next yr i'll pick up a cheap Barton tho.
The reasons are all stated above, but u dont have what i would call a generic PSU... its more of a middle of the line PSU made by a respectable manufacturer
I have the same PSU and i agree its great :D
Hey guys im looking for a general purpose printer (for papers and reports with minor pictures) for my dad's house
I currently have a HP 930C at my mom's and have had problems with a previous Canon and Epson printer so im willing to stay HP even tho i kno they are more expensive
I need this to...
thanks again guys, i tried spraying a compressed air can upside down for ten seconds and then a twist with a screwdriver and it popped right off, epoxy and all still attached to the heatsink :) Actually most of the writing on the core was still on the sink but the core itself was undamaged
Now...
i couldnt stand the noise from my WD 40GB drive so i took it out and got a 80gb Seagate IV, its sooo quiet - best decision i ever made :D
Oh and did i mention that i had 2 other WD 40GB drives die before? 1 in only a week too :/
Hey guys
About 5 months ago, the fan on my GF2 died. I then bought a Vantec Iceberq to replace the whole unit + get better cooling
The problem is the HS is epoxied on VERY tight and any way i could try to get it off failed (freezer etc..) so i then got the idea to take the fan off my old TNT2...
if u want to OC that 2100+, u could just bump it to 166 fsb and then its 2157mhz and all u need is PC2700 ram to keep the prices low...
i would just hope that allied psu will be ok.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.