Recent content by rtrg

I have several of these mobos from both the dimension 8100 and the optiplex gx400. Only the on board audio diffrenciates the two. The cpu is an INTEL 850, clock speeds from 1.2 through 1.9. What is the fastest speed this board will support AS IS? No additional hardware or software. I know this...

If I understand you want to move your existing SYSTEM into a new ATX case in order to add more hdds. Am I correct? I am a DELL die hard and I can tell you from experience this is never easy. Fierst you need to determine whether the mobo/psu is ATX or PROPRIETARY. ALL DELLS from 1996 through 2000...

Can someone here provide me with a list of vendors of vhs camcorders that all used the same edge contact sla battery in a shell? The SHARP part# is BT21/22, 12volt 2AH. I need the brand names both vendors and retail names and their camera models and their part# for this same battery...

Can I replace my single 12 volt 2ah sla from my batteries shell and replace it with a nimh pack of the same specs that will fit into the shell? What run time should I expect? Different charger? Faster charge than sla? All help welcome.

I have rebuilt a couple of packs using LI ION 4400 ma cells. All 15 packed into the shell, no neck cell, only the +/- tabs/wires. The charger in question is a "POWERIZER" brand model #ho2400918-us-1. Charge current .09a or 1.75 a in auto mode. One GREEN/RED indicator, one pigtail with temp...

From what you said am I correct in presuming that you think I could use my third party non RYOBI 2 wire charger with TEMP sensor attached to a pigtail and tape it to the NECK and discinnect after 1 or 2 hours? As it is a QUICK charger.

Thanks. Maybe someone there can answer my question.

Please move as needed. Can a RYOBI 18 volt pack of either NICAD or LI ION be charged using the 113,114,115 chargers if the TEMP sensor is missing? I rebuilt a number of them using LI ION cells with out the temp sensor simply because the charger I use has a PIG TAIL with sensor attached that can...

I have an affinity for DELL mobos. As you know they are proprietary and unique. I believe they are referred to as BTX form factor. Are there any third party cases, cheap price, that will accomodate these boards? I use the board from a optiplex gx400, 4H665 board number. The issue is with a...

For whatever this is worth, I have an affinity for the dimension and optiplex models of that vintage, 8100/gx400. I fix, set up, give away computers for those in need. Since DELL took the proprietary route, mix and matching is very difficult as you already know. I have used a number of simple...