Recent content by PVD

ttt

Ok guys. I have a BFG 6800GT card that is locking up in games (esp Command and Conquer Generals). I have the latest drivers/game updates. I have AGP fastwirte diabled in bios. I called BFG who suggested it might be a IRQ sharing problem as I am running XP. My VC has its IRQ at 16 and is sharing...

i originally said Leadtek, got mine from ewiz.com and it was broken right out of the box. Had to RMA it. Went out and got a BFG and it is a good card. It won't overclock to Ultra speeds without artifacts on HalfLIfe2. Damn shame. Oh well. It at least worked out of the box.

cmon guys. What am I gonna run that is gonna crash my system if I can do Prime for 30 minutes?? Nothing. My voltage is already at 1.55v. How much higher can I go? I am only using 1.3 bios. 1.5v is max.

Finally. Upped my vore to 1.5 (now reads 1.52 in cpu-z), and over vid of 5%. I was prime 95 stable for 30 minutes before it errored. Not bad

that is what mine runs at too. Looks good. Should be fine...... Don't stress. I even have a xp-90

I purchased in early december. Ram is at 2-2-2-5 timings

2.65 baby

I am at 2.64 GHZ using 240 x11 and only have overvid set to 3.3% What is everyone else getting out of there 3500+ prime stable??

ttt

what is the max volts my Ram can handle?? Also, should I go the 10x multiplier route with higher FSB??

I have a ram divider ar 5:4 (166) iin my bios. I am currently at 2.64 GHZ with my 3500+. I have my OCZ El Platinum Rev2 ram set at 2-2-2-5 timings and 1t. ISn't it alot faster to run your ram 1:1?? I currently have the fsb at 240 (x11). How could I do this? Also, is it worth getiing the RAM...

my wavemaster kicks ass!! :)

you remove the back plastic mount of the stock heatsink, and screw the mount that comes with the xp-90. It is really easy, It only takes 2 screws. The xp-90 should only take you 5-10 minutes to install once you read the directions and know what to do. It really is a good heatsnk. Mt CPU stays...