Recent content by proneax

  1. P

    Levono new release date? buy now or wait?

    look around some more, try the forums at notebookreview.com and thinkpads.com The impression I get is, you MIGHT get your laptop late aug/early sept. Speculation is a July 15 release (most likely a paper release), some claim the new intel chipsets won't be ready until August which gives you...
  2. P

    The mobile Athlon 64 and motherboards

    actually its a 41% overclock. Impressive, yet somewhate expected with that core and the right mb setup.
  3. P

    The mobile Athlon 64 and motherboards

    MSI has just put out a new BETA bios 1.4b2 Guess what IT SUPPORTS MOBILES My system boots to default values (DTR - 1.55v 200mhz x10) AND I can adjust the htt and have it stick in the bios. NONE of these values were sticking for me in the past with any other bios, I was adjusting them with...
  4. P

    The mobile Athlon 64 and motherboards

    I would try upping the voltage - 1.45 seems low to be running 2.3ghz at. On another note, I'm running into a 2300 wall on my k8n with a 3200 dtr CG Core. Ram is on a /12 dividor so its actually running below spec, not the problem. HT multi tried at 3 no help SATA using port 3 - that got me...
  5. P

    The mobile Athlon 64 and motherboards

    Got all my stuff: 3200 DTR, K8N 1gig ocz plat. STUPID 948U is not here yet!!!!!!! Think it would be ok if i booted my system, just to bios, with a p3 heatsink just sitting on top of the processor?
  6. P

    The mobile Athlon 64 and motherboards

    What do you mean? It's certified for socket 754... No heatsinks are certified for dtr chips. Has anyone seen a performance difference between the zalman and another air cooler? It can't be worse than the stock cooler....
  7. P

    The mobile Athlon 64 and motherboards

    I assume you were using the cnps-7000(a)? I'm thinking of getting a 3200 dtr and a zalman to cool it. So, I have 2 questions. #One: where did you shave the 2mm off? Position 1 or 2 in this pic: Look Here Also thinking maybe you could take some off of the washer (labeled 3 in the pic) or...
  8. P

    Need help on wireless AP, Routers shared Internet

    What the config page is saying is that you want to use your wireless in Bridge mode, however it is unlikely that your SMC router in Room B is compatible with this mode. You may be able to set the AP up as a client (mode 3) and have it communicate only with the Router. If not just leave it like...