Recent content by poohbeer

dscp 46 = ef (expidited forwarding). same thing. And same results. Well, as far as I can see. Untill I find a command that's shows traffic flow for the 4 queues I cannot be certain.

The 2950's do have the Enhanced Image yes. No worries there. The way I understand it is that jitter can kill a voice application no matter how much bandwidth you've got and that's what we're trying now. Dump any traffic with dscp=46 into a priority queue so it gets as little delay as...

Anybody?

Situation: 2 VOIP PBX's connected over a network with some cisco 2950 and 3550 switches inbetween (among others). QOS is needed to keep jitter at a minimum. I'm trying to config a catalyst 3550 right now. PBX's set dscp=46 themselves so do not need to mark incoming traffic. According to...

Got a Cisco 2950 and trying to use 802.1q to connect it's vlans with an extreme networks summit48. For now however just the basic setup on the cisco not connected to the summit48 with 2 vlans. See my problem and the config below. I don't have any cisco experience so I might be doing something...

In airvents and stuff you indeed use plenum cable. But it DOES smoke though! :) riser: TOXIC! burn easely and keeps on burning even when the flame is removed. Fuels the fire itself. Plenum: TOXIC! but fireretardent (doesn't burn quickly) and goes out as soon as you remove the flame LS0H...

Hi folks, what I'm looking for is a (kind of) official website where I can read that Cat5e is enough to run gigabit ethernet over it. I know this is possible but someone has convinced my client that he needs Cat7 (go figure :disgust::roll;) to do this so I need some 'real' proof since their are...