Recent content by phantomxprime

right now its set on DD2-533, and CPU-Z reads the memory as operating at 266Mhz, so close to a 1:1 ratio, but the same issue occurs when booting up (when I put the FSB any higher). i tried setting it on DDR2-667, then clocking the FSB to a comparable, 1:1 rate, like 335, but my video card...

Has anyone else run into the problem of overclocking the FSB to a point where the mobo no longer detects the RAM? Right now, my FSB is set to 287 with a multiplier of 8x, and when i put the FSB any higher, my system freezes during startup when the mobo normally detects the amount of memory...