Recent content by Pepi

I tried the CMOS clearing, but it didn't boot, so I couldn't go to the other steps listed. Thanks for your posts - It's a shame my case was not such a one so these steps to be applicable. :)

The system did not even POST.(I was not even able to boot at default FSB and multiplier in order to change after that:() The MB is KT133A - it is all right (exuse me for not mentioning it).

It works absolutely fine now, but on 750MHz. The short-cut -> (just linked them:)) The question was - what could have happened so I could not make it run on 133x6 for example?

looked it all over - no signs of links between the pins - nothing bad looking removed the lead by a fine cloth and some spirit (still don't know if it is not bad for the CPU)

looked it all over - no signs of links between the pins - nothing bad looking

Don't go for the Compaq black kbd - I don't like it - too small - although In my country it can be found 5.5$ - 6.0$ (cheap enough)

I like SBLive - have no problems the sound is just fine (via Teac PowerMax 500/2)

It is the second time I see someone say there are problems SB+Win2K I have such a card, run Win2K - have no problem - like it (could say nothing about SC)

don't really know, but check that link - http://perso.club-internet.fr/farzeno/firmware/ there are lots of firmware and patches for region freeing the drive

I've got ABIT KA7 MB, SBLive!Value and Win2K - have absolutely no problems :) It's a shame I know nothing about SC except the name in order to try to give my oppinion about SB<->SC

HDD IBM 270MB for 275$ - Two weeks later it burned away.

Recently I tried to unlock a 750MHz Duron in order to use it with higher FSB and lower multiplier. I short-cutted the L1 bridges and tried to run the system. Suprisingly It did not boot. Checked the bridges - were OK. Tried 5-10 more times and gave away. After I removed the lead (I used lead...

Hi, I'm running a Slot A Athlon 600MHz for about an year now. Could anyone tell me what kind of temperature to expect(couldn't find it said anywhere)? Currently my CPU temperature is between 46 and 58. Could the results be improper because of impropper position of the termal part (between the...

I'm running an AMD Slot A Athlon on 600MHz. Can anyone say me which is the temperature I should expect? It currently goes on 46 to 58 C degrees. Isn't it too high? Could I have put the thermo part not where suposed? (put it somewhere between the radiator and CPU, but far from the fan as it was...