Recent content by notareal

Go SpeedFan Configure > Advanced > Chip > Property > set PWM 2 mode : Manual PWM Control from Thermal Cruise. If fanspeed is not shown (fan speed below 1000 rpm) cange FANx divisor to 16 or greater.

SpeedFan does now support K8NGM2-FID with the 4.29 beta 7 . It can change CPU fan speed smoothly, but will only report SYS Fan speed. EDIT: Won't report AUX Fan speed.

You are not alone... Both Neo HE and Seasonic S12 seems to be picky about the +12V line load. You might want to add some more load to +12V line. If you don't have a mid to high end GPU, you can add some resistor that gives you around 1A load. Look closer at the the SilentPCReview forum. NeoHE...

I am using 2 x Samsung SP2504C SATA at RAID 1 as a system drive for Windows XP with the MSI K8NGM2-FID, works OK. There where none problems with the RAID setup, just remember to install both nvidia RAID driver and storage controller when asked. There is only one little issue, cannot find any...

MSI K8NGM2-FID PSU test report.

Hope you get some verification. MSI support do not impress me much now. As I did report about problem with K8NGM2-FID and NeoHE 430, I got this reply: "You could check in the manual and find the basic requirements for PSU. One is that ATX 12V power connection should be greater than 18A...

I asked about this from the MSI support and suggested that they should change PC Alert to work without the need of administrative rights. Got this reply: