I have personally seen XP Home act stupid on large-"ish" networks with DHCP. The machine's DHCP lease expires, it's shutdown, another machine comes up and takes the address, and the XP Home machine refuses to get a new address. The Active Directory thing could be part of it too. We require...
I'm hard on my boss to replace my aging 800MHz powerbook. It's getting long in the tooth, and the C2D refresh should be here right about the time it gets on the budget.
Got a DFI Lanparty UT nf4 Ultra-D Tuesday. Modded it to SLI, and popped in all my stuff. Don't know why I did the mod except for "I can".
Preliminary testing:
First night I took the Ram to 234 2-2-2-5-1T@3.1v and it ran memtest for ~10 hours without errors.
Last night I took the 4200 to...
We have an Opteron 170 rig with 4GB of Ram doing this. We found that 2GB of ram just wasn't enough. Furthermore they do the live editing on a 4-disk raid 0 aray, and move it off to the RAID5 2TB SAN when they're done. We tried with a single Raptor at first, and it just wasn't enough. Haven't...
That board is a stepping stone/launch pad to let you break in for relatively cheap. You'll want to buy DDR2 soon, and once the new motherboards get more reasonable you'll want to get one.
If you're not a heavy overclocker I'm going to suggest the AsRock boards. They're cheap and great boards for the money. They are even an OK overclocker. I have my 4200+ clocked to 2.6@1.37v, and I can't make it lockup or give me an error. I tend to OC, leave it there for a week to test, then...
Got home and stopped it after no errors for 18 hours and 4 minutes. Temp got up to 57C during the hottest part of the day, but apparently it was a non-issue.
I don't install CnQ or enable it in my BIOS. I use RMCLock. It gives you complete control over FIDs and voltage.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.