Recent content by NdTRan

  1. N

    Intel 45nm OC Result Thread (Wolfdale E8400/E8500/E3110)

    So i just orthos it at 1.30625 volts for an hr again using coretemp 0..96.1 and everest they both still reading the same temps, still nothing over 50 at 1.3 volts. I hope these temps reading are correct. Anyone else putting anything more then 1.48 volts thru their cpu? How high are you guys...
  2. N

    Intel 45nm OC Result Thread (Wolfdale E8400/E8500/E3110)

    Is there a certain everest version you are using? ALso how is you idle temps, mine always starts at 45 and 36 on every boot no mattery the clock speed so far. Havent gotten any VID problems with mine.
  3. N

    Intel 45nm OC Result Thread (Wolfdale E8400/E8500/E3110)

    For 4.5ghz I was running at 1.4825volts, I did a vdroop mod on my mobo so barely have any vdrop if any on my evga 680. Yeah I figure 55 degrees is way too cool for 1.5v but its like less then 20 degrees here in NY last couple of days so could be why. Are you using vista or window xp, I am...
  4. N

    Intel 45nm OC Result Thread (Wolfdale E8400/E8500/E3110)

    after about 10 min I was in the low 50s on both core but nothing over 55 degrees. WHat voltage were you using at 4.5ghz for yours set up. Thanks
  5. N

    Intel 45nm OC Result Thread (Wolfdale E8400/E8500/E3110)

    CPU Name: E8400 FPO/BATCH #: Q746A514 S-Spec: SLAPL Pack Date: 1/11/08 Place and Date of Purchase: microcenter ~~~~~~~~~~~~~~~~~~~ Motherboard: evga 680i AR bios 32 CPU Volt: 1.3 FSBxMultiplier=Frequency: 444x9=4.0Ghz ~~~~~~~~~~~~~~~~~~~ Memory: crucial ballistix pc8500 Speed: 547...
  6. N

    DEAD: 320GB 7200RPM 16Meg Cache PATA= $80 - 15 = $65 plus tax

    any idea where I can get a 15 dollar off coupon? thanks in advance
  7. N

    Tuniq touching two R50 resistor on evga 680i mobo Q's

    Hi guys, I have a tuniq on the AR version of the evga 680i board and want to mount it so air is blown up out the 200mm fan on top of my antec 900 case instead of the rear exhaust fan. I have 3 question 1.) WHen mounted this way, the side of base of the tuniq that is on the cpu is touching the...