I am looking for a laptop. I know I want the centrino processor and cd-rw. I would also like a 15" screen. the wide would be better but not needed. Also it needs to be around 7.5lbs or lighter. What are good brands? I found this and was wondering about it.
here
THis is going to be...
I am totally lost when it comes to memory timing. I hear that you need tight for good OC but dont understand that. With my value ram I have from cpu-z
Frequency 133MHz 166MHz
CAS# Latency 2.0 2.5
RAS# to CAS# 3 3
RAS# Precharge 3...
these are very tempting to get. I was stuck between these and the klipsch, but heard lots of complaints about the amp dieing in the klipsch. Are these worse or better than the gigaworks s750 (saying that it will be using 5.1 not 7.1)?
I think that I have my fans setup wrong. I could use a litte extra cooling maybe moving them can help.
a picture
I tried drawing a picture of it, the blue ones are pulling in and red are pulling out. Is the back two fans cancling each other?
I just got an audigy 2 zs and my center speaker is not loud at all. I have cmss 3d enabled and cmss box picked. I turn up the center speaker all of the way and it still is not as loud.
I have altec lansing 251s. On the speaker calibration when I am on step 2-5 volume balance manager and I...
I can't even get into my bios. When I turn on the computer it beeps and the hd light comes on and the cd-rom drives lights comeon but the monitor stays off. It is like it is not even plugged into the computer. But once it did comeon and the bios said it did not detect any IDEs
I did repaired windows using the disk then reset and it detected no ides. The MB manufacture told me to reset the cmos and after I did that I get no picture. The monitor light stays orange like it is in standby.
I have an
asus p4p000 MB
intel 2.4c processor
kingston pc2700 512mb ram...
The video cable? I am using that one right now on a different pc. Before I sent my board off it came on once and still detected no IDEs. I am about to just test every part. New memory and video card.
I did a windows repair using the windows xp disk. After it got done the computer said it did not detect any ides. I had a dvd/rw, cd/rw and HD plugged in. I was told to try to reset the cmos. After I did that I would get no picture. The light on the monitor would stay orange and not turn...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.