Recent content by MrJ

This what you looking for? kk266 faq

Well, if you want low cost, "low" being a relative term, I will assume you would like to stay under $200 for the combo. I would recommend the Epox 8KTA3+ ($108) and A Duron CPU which can be had for $45-$90 depending on size. Newegg.comhas these parts at good prices.

Wish I could help you bud, but if you read my earlier post "Thank You EPOX!" You will see why I can't. Maybe you can get someone to help you figure out how to work one of those things. I think you have to be a rocket scientist though.

Yes it is 60mm and it fits perfectly on my KK266 IWILL. I had a board like yours and there is just as much room. ALSO...this HS was voted EASIEST to install too. Much easier than the Alpha.

I keep seeing AXIA and some other designation for t-bird cores. WHat is this and does someone have a link that lays it all out?

Here is the link for that site to see the Vantec Proton ComputersThey have A+ service. The Vantec FCE-62540D is the one to get.

I had the exact same HS/fan combo aas you on my 1.2 gig and ran into heat probs. I just bought a new Vantec HS with Sunon 38cfm fan and it rocks. My temps are down to 35 degrees now. I got it at www.protoncomputers.com and they are ranked #4 at resellerratings.com. Got the whole combo for...

I just recently re-installed my V5 after using a GF2 MX for a while. The last drivers I used were the 1.04 drivers. I have come across several other beta and leaked drivers around the net and need some recommendations on which ones seem to work the best. Any help with best drivers and setups...

I just recently re-installed my V5 after using a GF2 MX for a while. The last drivers I used were the 1.04 drivers. I have come across several other beta and leaked drivers around the net and need some recommendations on which ones seem to work the best. Any help with best drivers and setups...

Good question and I am not sure. I had it about 6 months. When I had my 1 gig it kept the CPU around 38-40 degrees. The Vantec is keeping my 1.2 gig at 35 degrees consisntently.

I just switched from an Alpha Pal6035/Sunon 28cfm HS/Fan combo to a Vantec/Delta 38CFM fan and dropped 10 degrees celsius off my temps. This Vantec HS is so much easier to install than the alpha too. I recommend this combo to anyone looking for a HS/Fan combo for a 1gig AMD or higher. I got them...

I have a power supply with 3,444,098 connectors...I am using most of them but WONDER, does it matter which connector goes to which card or drive?? I mean, if I connect say my Hard Drive to one connector and then connect my sound card to the one of the other connectors on the SAME wire, will it...

I have a power supply with 3,444,098 connectors...I am using most of them but WONDER, does it matter which connector goes to which card or drive?? I mean, if I connect say my Hard Drive to one connector and then connect my sound card to the one of the other connectors on the SAME wire, will it...

I just re-installed my V5 after using an NVIDIA card for the past few months. I haven't been able to find any drivers other than the 1.04. Are there any newer ones out there?

Played Rainbow Six 6 hours a day on-line for 2 years. Then discovered UT and Q3. Played them a while and tried CS. Eventually got SICK and TIRED of all the cocky, lying, cheating MORONS I had to deal with in on-line gaming so now I only play Single Player games. Started playing NOLF, Project...