Recent content by MGOtis

abit kg7 tbird 1.4 266 crucial 256 pc2100 visiontek gf2 gts 32mb I have two HDs, both WD, one 13.6 gig, one 40 gig. I usually boot off of the 13.6 and the 40 gig just has assorted data on it. I recently switched these two HD's to this new system. I formatted the 13.6 gig and did clean...

Yeah, I'll try reseating it again. Don't believe I can switch banks, however. The manual specifically notes that the banks need to be occupied from DIMM4 to DIMM1. Thanks again for the replies.

Oops! Sorry about blank. Thank you for the URL, it's very informative. However, I've run across the same problem in that the beeps I'm recieving do not correspond to any of the beep codes listed. Thanks for trying ;) I just had someone mention that long continuous beeps are often related to...

*bump* anyone?

Thanks for the reply :) That is by far more comprehensive than any other BIOS pages I've found. However, the same problem still arises. That is that none of the listed beep codes seem to correspond to the beeps I'm getting. The beeps I'm getting are the same in duration and at regular...

Okay, just putting a new system together. Abit KG-7 w/ an AMD 1.4 Tbird 266. 256 megs crucial DDR. When I try to boot the system, I get no signal to monitor. but it seems that the card is seated correctly. Also, the BIOS gives one long beep after another, which isn't what I got on my other...

That kind of makes sense, but that doesn't make sense to me there is that BIOS recognizes both drives correctly... it's only when I try to get into windows that I experience problems. Did you experience the problems in the BIOS or just when attempting to load windows?

Hello, I bought a WD 5200 RPM 40 GIG HD today. I also have a WD 13.6 gig 7200 rpm drive. I installed the drive, and the BIOS sees both drives correctly. However, when it's loading windows, the windows screen comes up, then it goes black with a cursor in the upper left, and will not finish...

Hello, I recently uninstalled a proggie that was set to start on bootup into Windows (98se) and load into the sys tray. Now, upon getting into windows, I get the "searching for file" message. My question is, how do I remove the command to start that program up automatically, so Windows...

Abit KT7 Duron 600@850 128 megs generic PC100 WD 13.6 7200rpm HD When I first built this computer, it booted flawlessly. Now, it rarely will POST on a cold boot. If I hit reset once, though, it typically boots correctly. More recently though, I have noticed that I have to hit reset 3 or 4 times...

Okay folks, I know someone with a mobo that supports chips up to 500mhz, but he has a 600mhz Celeron chip. What'll happen if he throws it in that board? Will it just not boot? Screw up the proc? Thanks for your info. O

I don't know... I can't hear much over my FOP-38 :D O

Excellent! Those drivers appear to have worked! Now I just have to get a game loaded and see if it recognizes. Thanks a ton! :D Now I can squeeze another month or two outta my v2's. O

Okay. I'm on Win98 SE. There are no working drivers. The latest drivers will not even let windows run... it either freezes or just autoreboots. After using the latest, it will not let me load other drivers, as I guess the latest includes some .dll files that the earlier ones do not and when I...