Recent content by matteope

Is it harmful to lower it without installing a fresh copy first?

::BUMP::

I have about 70 gigs of stuff that I would want to keep on the one partition. Any other suggestions?

I have a 120 gig hard drive and I partioned it into 2 partitions, a 5 gig and a 95gig (lost 20 gigs somehow...) Anyway, My 5 gig drive that holds windows has recently been "shrinking" in size. It has happened before, I formated my drive and re-installed windows, but it seems to be happening...

Well, I just moved it over to the other ram slot and it worked. I dont get why though when they told me 1 and 2 were for DDR. Anyways thanks for all your guys help! Sureshot I was curious to what your computer specs are? Email me at matteope@eden.rutgers.edu if you wouldn't mind. ~Matteo

Ok tks, lemme try those 2 ideas.

**bump**

I checked that and they are in the correct slots. It worked in these slots before, I wouldn't see why they wouldn't work now :( ~Matteo

I DL'd CPU-Z Version 1.8, there was newer versions there that I will try out. That still doesn't explain the message when I boot up saying "Memory Mode: Single Channel." **EDIT** Version 1.9 also says Single. ~Matteo

I have looked, do you happen to know where this is located? ~Matteo

Haha of course. I accidently hit back and lost post so tried to do over quickly. My question is quite simply, How can I get back to "Memory Mode: Dual Channel?" I went and DL'd CPU-z and that confirms that I'm running Single channel memory. Thanks, ~Matteo

Hello, I've noticed on boot up that my computer is only using "Memory Mode: Single Channel." I have a MSI K7N2-L Mobo with Dual Channel DDR support. About a week ago, my computer read that it was "Memory Mode: Dual Channel" so I am curious as to what changed it. I recently had a...

I am now typing from my own computer ! Switching the jumpers the way you described Viper worked great, and then after I could boot my computer I went back into Bios and set the fsb to the correct value of 133 enabling it to run at 2200+ again. Thanks alot for all the help and suggestions...

I do know how to reset your CMOS and yes I have read the manual. I've taken the battery out for 5min then put it back in to see if that would work and no luck. I see in the manual about the fsb mode jumper. I will do as you say and see if that works. It might take a bit because I have to go...

I wasn't trying to overclock, it was a stupid mistake. I hadn't messed with my bios since I built the computer and I thought it ran on 166. Im just an amateur when it comes to building computers so please educate me on what you mean by Palomino or Tbred-A core?