Recent content by mathiasadsl

Thank you rudder, I use a thermaltake 3 pins. It's already plugged in the 4 pins connector motherboard. Therefore 1 pin is not used. My main problem is that there's no auto-regulation speed of the processor fan. In a previous message altiyyab said that without a 4 pin fan connector the Bios...

Thank you, I've got 2 others connectos 3 pins: -At the back. -At the Front. If I plug my processor fan on the Back connector fan, usually used for the tower temperature... Will the motherboard be able to increase/decrease the processor speed fan in auto/mode? Therefore I can conclude...

OK, I've just pluged my fanmate from zalman. it comes with a 3 pins connector too. So on the motherboard there's 1 pin which is not used. Now, I'm able to control the fan speed but manually. I set to 800rp/min (Notified by Everest Software). I can hear the silent... The only solution to...

OK I'm gonna buy the fanmate from Zalman but I'll have to check my CPU Temp during the summer... However I dont even know what is maximum temperature that a Core Duo E6400 can support? With my thermaltake fan, when I run the "stability test" from Everest, I reach about 60°C. If a 3...

Thank you Alitayyab, I checked this morning in the specification motherboard. You're right, the motherboard fan connector is a 4 pins. My Fan Thermalatke comes with a 3 pins only. Do you know if there's a way to convert a 3 pins -> 4 pins connector? Mathias From France

Hi, I've just installed this MotherBoard with the E6400 Core Duo. It's stable but I have a problem with the Processor Fan (Thermaltake orbit Blue II). Even when I dont load my computer the fan runs a 1600rp/min. When I try with everest to "BottleNeck" the cpu with a loop program, the cpu...